Digicom 8D5684QB Guide de l'utilisateur télécharger pdf (Page 13)

2.5

Pocket AL I/O QB QB Installation

2.1.7. Powering on for the ﬁrst time

• OncethehardwareinstallationisoveritisnecessarytocongurePocketALI/OQB.

• AttherstpoweroncheckthestatusofPowerandStatusled.

• AfterfewsecondsPocketALI/OQBwillregistertotheGSMnetworkandthePowerledwillstartblinking;theStatusledwill

give the indication of the signal. In case Power led is ﬁxed on or the Status led is off, power off Pocket AL I/O QB and verify

as follows:

 -theSIMiscorrectlyinsertedintotheSIMslot;

 -thePINcoderequestisdisabled;

- the GSM quality signal (insert the SIM card itself in a mobile phone).

2.2. LED INDICATORS

You can control the status of Pocket AL I/O QB through two leds:

LED STATUS DESCRIPTION

POWER OFF Device off

ON Power on and search for network

BLINKING Device registered to the GSM network

SLOW BLINKING Device powered by battery

STATUS OFF Trouble condition: search for network, low GSM signal, no

SIM, PIN request or registration in Roaming (see command

#GSM#)

SLOW BLINKING Good GSM signal

FAST BLINKING Receiving SMS. 3 seconds sequence time

ON Sending SMS. 3 seconds sequence time

Note: in case the device is powered through a battery, the Power led will show this status (slow blinking);

refer to the Status led to control the registration status.

2.3. BACK-UP BATTERY

The battery backup is placed into the product.

Back-up Battery features: Li-ion 3,7V – 950mAh rechargeable.

At the ﬁrst power on, leave the device connected to the power supply for at least 5 hours for a correct and complete battery charging.

You will have the best performance in battery autonomy after 2 or 3 cycles of complete charge and discharge.

2.3.1. Remove the back-up battery

The replacement of battery must be carried out by qualiﬁed staff in

our maintenance centre.

In special cases, to remove the battery disconnect the device from

the main power.

Open the device, removing the terminal board panel.

Disconnect the connector as shown in picture.

Remove the board ﬁrst, then you will be able to remove the battery.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Pas de commentaire

Digicom 8D5684QB Guide de l'utilisateur Page 13